banner

Controller module

Home

Controller module

  • BCKF01 GE Controller module
    The BCKF01 is constructed with a durable, corrosion-resistant aluminum housing and features a single-stage, backward-curved impeller for efficient airflow and low noise levels. The blower is also equipped with a built-in thermal overload protector to prevent motor damage.
    Read More
  • AK9840 DOLD Controller module
    The asymmetry relais AK 9840 of the VARIMETER series monitors voltage asymmetry, under voltage, phase failure as well as incorrect phase sequence at three-phase mains. The measurement is very simple and can be carried out without much wiring effort, as no separate auxiliary voltage is required. Early detection of impending failtures and preventive maintenance prevent costly damage and as a user you benefit from the operational safety and high availability of your system.
    Hot Tags : DOLD AK9840
    Read More
  • RTU520 ABB programmable controller module
    The document describes the requirements and installation steps needed to build up a full RTU500 series engineering environment. The base configuration of the Microsoft Windows Operating System and the tools required for the engineering process are described. System requirement are defined in chapter Chapter 2.7 in figure "Fig. 28: Page for general information and pre-requisitions" 
    Read More
  • 1SDA053954R1 ABB Controller module
    ABB 1SDA053954R1 T2S SACE Tmax 3P 50A 480V Breaker W/Bolts (CHIP)
    Hot Tags : 1SDA053954R1
    Read More
  • FC-TPSU-2430 HONEYWELL programmable controller module
    Honeywell has made several advancements to the SMS Power Supply based on observations from the field. The design and manufacturing techniques have been altered to increase the ability to withstand dust build up across the High Voltage circuit. These modifications make the unit more robust against adverse environmental conditions which can lead to failure.
    Hot Tags : HONEYWELL FC-TPSU-2430
    Read More
  • HONEYWELL  CC-TFB811 Gate Module
    Experion Series C input/output chassis-less mounted modules and field level network gateways provide the physical connection between an automation system and the process when used with the C300 Controller. Input/Output Modules and field terminations are combined in the same area. The Input/Output Modules are plugged into Input /Output Termination Assemblies to eliminate the need for a separate chassis to hold the electronics assemblies. 
    Hot Tags : CC-TFB811
    Read More
  • CC-U/STD ABB Controller module
    More than 120 configurations possible Configurable output signal response on input signal interruption (low fail safe / high fail safe) Adjustment and operating elements on the front-side Short-circuit proof signal outputs Plug-in connecting terminals for inputs, outputs and supply Very fast signal transmission enables use in control systems
    Hot Tags : CC-U/STD
    Read More
  • 6ES7331-7KF02-0AB0 Siemens Controller module
    SIMATIC S7-300, Analog input SM 331, isolated, 8 AI, Resolution 9/12/14 bits, U/I/thermocouple/resistor, alarm, diagnostics, 1x 20-pole Removing/inserting with active backplane bus
    Read More
  • TXI2.OPEN Siemens  Controller module
    Integrates third-party systems and devices in Desigo (V4.1 or higher) The TX Open RS232/485 module integrates third-party systems via RS232 or RS485 interface to the Desigo building automation and control system. The required applications are loaded onto the module via the USB interface. 
    Hot Tags : TXI2.OPEN
    Read More
  • PNOZX3 A-B Controller module
    This document is the original document. All rights to this documentation are reserved by Pilz GmbH & Co. KG. Copies may be made for the user's internal purposes. Suggestions and comments for improving this documentation will be gratefully received. Source code from third-party manufacturers or open source software has been used for some components. The relevant licence information is available on the Internet on the Pilz homepage
    Hot Tags : A-B PNOZX3
    Read More
  • 800T-XD2P A-B Controller module
    Rockwell Automation announces that as of December 31, 2019, the 30mm Contact Block 1-NC 800T PB will be discontinued and no longer available for sale. Customers are encouraged to remove references to the affected product(s).
    Hot Tags : 800T-XD2P
    Read More
  • RTU520 ABB Controller module
    Power supply 520PSD01 RTU520 product line Application, characteristics and technical data have to be taken from the hardware data sheet: 520PSD01 data sheet 1KGT 150 823 Operation The power supply unit 520PSD01 is used to generate the necessary power for the RTU520 system. The 520PSD01 is connected directly with the 520CMD01 via connector X1 (see Figure 1and Figure 2). The RTU520 system could only be supplied via the 520CMD01 board, other boards aren’t provided. The input voltage is not galvanic isolated against the output voltages. 
    Hot Tags : RTU520
    Read More
1 ... 144 145 146
A total of146pages

Leave A Message

Leave A Message
If you are interested in our products and want to know more details,please leave a message here,we will reply you as soon as we can.
Submit

Home

Products

whatsApp

contact