Programmable controller

Forward Looking Statements We describe many of the trends and other factors that drive our business and future results in this presentation. Such discussions contain forward-looking statements within the meaning of Section 21E of the Securities Exchange Act of 1934, as amended (the Exchange Act). Forward-looking statements are those that address activities, events, or developments that management intends, expects, projects, believes, or anticipates will or may occur in the future. They are based on management’s assumptions and assessments in light of past experience and trends, current economic and industry conditions, expected future developments, and other relevant factors

The SmartLine family pressure transmitters are designed around a high performance piezo-resistive sensor. This one sensor actually integrates multiple sensors linking process pressure measurement with on-board static pressure (DP Models) and temperature compensation measurements.

Honeywell has made several advancements to the SMS Power Supply based on observations from the field. The design and manufacturing techniques have been altered to increase the ability to withstand dust build up across the High Voltage circuit. These modifications make the unit more robust against adverse environmental conditions which can lead to failure.

The Woodward 8251-055 is a proportional actuator designed for use on diesel, gas, and gasoline engines, or turbines. It is part of the EG-3P family of actuators, which are known for their reliability, durability, and performance.

Thank you for choosing the Smart Radio AIS Receiver. The SR161 and SR162 receivers are high quality AIS receivers that use VHF technology. These units make it possible to receive information from ships, buoys, lighthouses, SAR helicopters, coast guard units, pilot boats, weather stations, etc. that are equipped with Automatic Identification System (AIS)

The document describes the requirements and installation steps needed to build up a full RTU500 series engineering environment. The base configuration of the Microsoft Windows Operating System and the tools required for the engineering process are described. System requirement are defined in chapter Chapter 2.7 in figure "Fig. 28: Page for general information and pre-requisitions" 

Representative Rendering, Not The Actual Product 700-N Industrial Control Relay, 4 N.O., 110V 50Hz / 120V 60

The implementation of safety concepts is facilitated significantly through the use of drive-integrated safety engineering and its use also simplifies the verification of the required safety category for a machine. 

Each channel's 250-Ohm load resistor is connected to the input terminal through a wire jumper on the IOTA. This jumper should be cut by the user on channels to be used with voltage transmitters. For channels 13-16 the low-side input connection is normally connected to system common by a wire jumper on the IOTA. This jumper may be cut by the user to enable differential operation subject to operating within the CMV specification.

Plug-in relay, 3 changeover contacts 230 V AC, 10 A, Width 22.5 mm for LZS sockets 

This product was certified with the above certifications as of 2024-06-26. Products sold before or after this date might carry different certifications. Please review the product label to check for the certifications your specific product carries.

Representative Photo Only (actual product may vary based on configuration selections)